Most Popular Parts
These are the most commonly purchased repair parts for A207.
-
(20)
There are two belts under a Maytag washer; one for the main drive pulley and one for the water pump. The belt kit includes both the drive belt and the pump belt which are both "V" shaped. The belt connects the drive motor to the drive system to be able to spin the tub basket. If your washer will not agitate, not spin, or not drain, the belt could be worn or damaged and will need to be replaced. This is a genuine OEM kit. Please remember to disconnect the power and shut off the water supply to your washer before starting your repair.
-
(4)
This rubber injector valve is commonly known to cause a leak at the top left corner of the outer tub. It fits over the injector nozzle. This part helps control the water flow rate from the fill valve to the tub. If your washer is leaking you may need to replace this part. This injector valve is a genuine OEM part. Please remember to disconnect power to your washer before starting your repair.
-
(1)
This shaft seal comes filled with grease on the inside, and is used for washing machines.
-
(3)
The tub bearing kit is used on 2-belt washers. This part helps keep the interior tub spinning correctly. If your washer is leaking, noisy, or shakes and moves, you may need to replace the tub bearing. It is recommended to change the seal kit at the same time you are replacing the tub bearing. This is a genuine OEM part. Remember to disconnect the power and shut off the water supply to the washer before starting your repair.
-
(8)
This washing machine drain pump is intended for use with automatic washers that have been manufactured since 1958. The pump itself is made of plastic, though it does come with a metallic belt pulley.
-
(5)
This water inlet valve has two ports for water to enter. It is blue and is intended for use with many washing machines and comes with a multi-mount bracket and an outlet adaptor. The water inlet valve controls the water flow into your washer. If your washer is leaking, will not fill with water, has no hot/cold water, or will not stop filling with water, you may need to replace the valve. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before you start the repair.