Most Popular Parts
These are the most commonly purchased repair parts for ABC2037DEB.
-
(15)
The crisper drawer is used for storing fruits and vegetables at a humidity level that will help them stay fresh longer. If the crisper drawer is damaged, you may need to replace it. This crisper drawer is made of clear plastic and measures 12.847" depth by 15.217" width by 6.93 height. This part is sold individually and does not come with the plastic faceplate on it. If your current crisper drawer has one, you will need to remove it and transfer it to the new crisper drawer. NOTE: As per the manufacturer, the crisper drawer has been updated from the original. A new crisper cover may need to be purchased for the drawer to work.
-
(43)
This is a replacement ice maker assembly. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part. NOTE: This part has been updated by the manufacturer and does not include the cover, ice level arm or the wire harness. You can reuse those from the original ice maker.
-
(7)
The pantry drawer lid helps keep everything inside the drawer, it acts as a cover and keeps your drawer at the proper temperature by creating a seal. If the door will not open or close, or if the drawer section is too cold, you may need to replace the lid. The pantry drawer lid is a genuine OEM part.
-
(11)
This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.
-
(8)
This part is snapped onto the top portion of the evaporator. The thermostat sends temperature information to the processor. The defrost heater must be replaced when replacing the thermostat.
-
(6)
Frame only. Glass is not included.