Admiral Dryer ADG7000AWW
Repairing your ADG7000AWW Admiral Dryer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
ADG7000AWW model diagrams below. Trust us to help you find the part you need and get your
ADG7000AWW Admiral Dryer running again.
Diagrams for Admiral ADG7000AWW Dryer
There are 9 diagrams for ADG7000AWW. Click on the diagram where you think your part is located.
Most Popular ADG7000AWW Parts
These are the most commonly purchased repair parts for ADG7000AWW.
-
(66)
This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(10)
This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(8)
This genuine OEM white blower wheel has a deep D-shaped shaft receptacle, 7 1/8-inch hub diameter, 8-inch fin diameter, 1/2 -inch diameter motor shaft, 3 1/8-inch deep, 20 standard fins, 3/8-inch motor shaft diameter to flat side of the shaft. The blower wheel attaches to the drive motor shaft and blows the air through the drum and out through the exhaust. The spring clamp is not included with this part. Please be sure to disconnect the power to your dryer before starting your repair.
-
(4)
This part is the replacement thermal fuse for your dryer. It measures a little more than an inch wide, and about ¾ inch long. The thermal fuse is a safety device that shuts off the burner in a gas dryer, or the motor in an electric dryer when the dryer overheats. If your dryer will not start, or if it is not producing any heat, you may need to replace the thermal fuse. Be sure to disconnect power to the dryer before you begin this repair. This part is sold individually and is an authentic OEM part sourced from the manufacturer.
-
(1)
This is the replacement motor pulley for your dryer. The motor pulley transfers momentum from the drive motor to the drum via the drive belt. If the motor pulley cracks or is no longer staying on the drive shaft, you will need to replace it. You will need to access the dryer motor for this repair, by removing the front panel. The motor pulley is approximately 1 inch in diameter and is sold individually. This is an OEM part sourced directly from the manufacturer.
-
(3)
The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This lint filter screen has two side guides on either of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide. This is a genuine OEM part.