Admiral Dryer ADG7005AWW
Repairing your ADG7005AWW Admiral Dryer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
ADG7005AWW model diagrams below. Trust us to help you find the part you need and get your
ADG7005AWW Admiral Dryer running again.
Diagrams for Admiral ADG7005AWW Dryer
There are 6 diagrams for ADG7005AWW. Click on the diagram where you think your part is located.
Most Popular ADG7005AWW Parts
These are the most commonly purchased repair parts for ADG7005AWW.
-
(2)
The spring for this part is sold separately.
This idler assembly is for dryers.
Idler assembly includes the idler arm and the idler pulley that maintains tension on the drive belt, allowing the belt to turn.
Disconnect the power before installing this part. Wear work gloves to protect your hands.
-
(1)
This part replaces older two terminal switches.
-
This single drum support roller is used for square-ported model clothes dryers. It has a metallic bearing in its center. This support roller is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, will not tumble, or takes too long to dry, you might need to replace the roller. It is recommended that you replace both rollers at once. It is sold individually.
-
The felt seal keeps the hot air in the dryer drum. It is located between the back of the drum and the rear dryer panel. If your dryer is noisy, or the seal is damaged, you will need to replace it. This is the seal only; the high temperature adhesive is not included. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.
-
(3)
This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.
-
These brackets support each side of the tub. Order quantity needed.