Admiral Dryer AGD4475TQ0
Repairing your AGD4475TQ0 Admiral Dryer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
AGD4475TQ0 model diagrams below. Trust us to help you find the part you need and get your
AGD4475TQ0 Admiral Dryer running again.
Diagrams for Admiral AGD4475TQ0 Dryer
There are 4 diagrams for AGD4475TQ0. Click on the diagram where you think your part is located.
Most Popular AGD4475TQ0 Parts
These are the most commonly purchased repair parts for AGD4475TQ0.
-
(66)
This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
The tri ring is used to hold the drum support rollers or the idler pulley onto the shaft. If your dryer will not tumble or is noisy, you may need to replace the tri ring. This is a genuine OEM part and is sold individually.
-
(10)
This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(21)
This 3-wire with leads dryer door switch is an on and off mechanism that prevents the dryer from operating while the door is open. The dryer will not operate until the door switch signals that the dryer door is closed. If the dryer won’t start, the lever broke off, or the switch shorted out, the appliance will not operate and the part will need to be replaced. This switch is a genuine OEM part and replaces the 2-wire switch. Please remember to disconnect the power to the dryer before starting the repair.
-
(4)
This door seal does not include the adhesive glue.
-
(10)
This seals Includes adhesive. This part helps seal the drum to prevent hot air from escaping.