Most Popular Parts
These are the most commonly purchased repair parts for AGDS902E-P1131833NE.
-
(6)
This part is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter, be very careful not to touch the black element part of the igniter as it is very fragile. You will need to reuse the original bracket when installing the new igniter.
-
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2" x 12-3/4" x 16-3/4" and is a genuine OEM part.
-
(1)
The oven door hinge assembly attaches to the right side of the door allowing the oven door to open, close, and stay open at an angle. If your oven door is not working properly then you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures approximately 11 1/2” long, is made of metal, includes a spring and two screws. This is a genuine OEM part.
-
This electrode mounting screw is well under an inch long. It is made entirely of metal and has a Philips head.
-
This is a genuine OEM part that is used inside your range/oven to provide a durable surface for your cookware. The rack measures approximately 23 inches wide and 16 inches deep. The part is made of metal and is sold individually.
-
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.