Inglis Washer ITW4300SQ0
Repairing your ITW4300SQ0 Inglis Washer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
ITW4300SQ0 model diagrams below. Trust us to help you find the part you need and get your
ITW4300SQ0 Inglis Washer running again.
Diagrams for Inglis ITW4300SQ0 Washer
There are 8 diagrams for ITW4300SQ0. Click on the diagram where you think your part is located.
Most Popular ITW4300SQ0 Parts
These are the most commonly purchased repair parts for ITW4300SQ0.
-
(5)
This is not the full agitator assembly. This is just the agitator base.
-
(12)
The clutch assembly is used on direct drive washing machines and helps spin the basket during the spin cycle to remove water from the tub. If your clutch is worn out it can cause the washer to be noisy or leave water in the tub because it won’t drain properly, which will leave your clothes soaked. The clutch assembly includes a brake cam driver, retaining ring, bearing, and a spring, depending on your model number. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the washer before starting your repair.
-
(32)
The newer version of the coupler kit is made with new metal sleeves for added strength. This part is located between the motor and transmission on the direct drive washer that does not have a belt. The coupler will break to protect the motor from damage if the drive motor system seizes up. If your washer will not fill, will not agitate or spin, but it will drain the water from the tub, you may need to replace this part because it has failed. This is a genuine OEM part. Disconnect the power to your washer before starting the repair.
-
(9)
This pump is intended for use with washing machines that do not have belts. This drain pump has two ports for water to pass through: a large one, and a smaller one. This part is used to remove water from the tub during the drain cycle. If your washer is leaking, not draining, pumps but will not spin or fills and drains at the same time you may need to replace the pump. The pump is located on the motor and is attached by two clips. This part is white in color, made from plastic and is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(2)
The drum is driven directly by the motor, replacing the usual belt or gearbox-driven system which increases efficiency and decreases noise. NOTE: The cardboard is not included with this part.
-
(6)
The timer (60 Hz) controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.