Most Popular Parts
These are the most commonly purchased repair parts for KSCS25FKSS02.
-
(12)
This is a genuine replacement light bulb for a refrigerator. The inside of your refrigerator should illuminate when you open the door. If your fridge does not illuminate, you may need to replace this part. It is smaller than a standard light bulb, but has a standard size screw-in base. It measures about 3.75 inches in length.
-
(11)
This 8-cube ice maker is used to help produce ice for your refrigerator. The ice maker receives water from the water inlet valve and will freeze the water until ice cubes are formed. Once the water has been frozen the ice cubes will be ejected from the mold into the ice bucket and will refill with water to repeat the process until the ice bucket is full. This ice maker does not include the bail or shut off arm. You can reuse the arms for your old ice maker or you can also order them separately if required. It does come complete with flat and round plug wiring harness, the mounting hardware, and the instructions. The harness can be reused. This ice maker will not fit refrigerators that have the ice auger mounted on the door. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.
-
(7)
This ice door is used to seal off the ice chute when not in use. When in use the door will open in the dispenser chute to allow ice to be dispensed. This kit includes the ice door, support, spring, and delay. The heater ribbon is no longer attached. The heater is no longer needed due to an authorized update from the manufacturer. If your ice maker won’t dispense ice or frost build up you may need to replace the part. Please remember to disconnect the power to the refrigerator before starting your repair.
-
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.
-
(1)
This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker isn’t making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.
-
(2)
Comes with the rollers for easy gliding.