Most Popular Parts
These are the most commonly purchased repair parts for MFD2560HES.
-
(41)
The pantry end cap attaches to the inside of the refrigerator cabinet to support the pantry drawer. This is a kit and it includes the left and right end cap. The part is made of plastic, is white in color and measures 24” long. This is a genuine OEM part.
-
(17)
This is the center support rail for the refrigerator crisper drawer. This rail supports center of the crisper frame.
-
(43)
This is a replacement ice maker assembly. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part. NOTE: This part has been updated by the manufacturer and does not include the cover, ice level arm or the wire harness. You can reuse those from the original ice maker.
-
(7)
The pantry drawer lid helps keep everything inside the drawer, it acts as a cover and keeps your drawer at the proper temperature by creating a seal. If the door will not open or close, or if the drawer section is too cold, you may need to replace the lid. The pantry drawer lid is a genuine OEM part.
-
(7)
Commonly referred to as the flapper assembly, the door mullion is an important part of a double, or triple door refrigerator.
-
(11)
This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.