Magic Chef Dryer YG20HN3 Sections

There are 14 diagrams for YG20HN3. Click on the diagram where you think your part is located.

CABINET (REV. J / 10)

CONTROL PANEL

CONTROL PANEL (REV. J / 10)

CONTROL PANEL (YG20H3) (REV. E

CYLINDER & DRIVE

CYLINDER & DRIVE (YG20H3) (REV

DOOR (REV. J / 10)

EXTERIOR

EXTERIOR (YG20H3) (REV. E - H)

GAS CARRYING

GAS CARRYING (REV. J / 10)

GAS CARRYING (YG20H3) (REV. E

MOTOR & DRIVE (REV. J / 10)

TUMBLER (REV. J / 10)

Most Popular Parts

These are the most commonly purchased repair parts for YG20HN3.

Multi Rib Belt - 92-1/4"

CAD$19.75

In Stock

(66)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
M Series New Style Coil Kit

CAD$35.48

In Stock

(10)

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
Screw, 8/18 x 3/8

CAD$6.22

In Stock

This screw is sold individually.
Door Catch Kit

CAD$37.15

In Stock

(4)

The door catch helps keep the door closed while the machine is running. If your dryer won’t start or the door won’t close you may need to replace the door catch. This is a genuine OEM part and includes both the male (strike) and female (catch) pieces. Please remember to disconnect the power to your dryer before you start the repair.
Lint Duct Housing

CAD$145.07

Special Order

(1)

Does not include the seal
Lint Filter

CAD$67.35

In Stock

(3)

The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This lint filter screen has two side guides on either of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide. This is a genuine OEM part.