Hotpoint Range Parts

Bake Element - Push On Terminals - 240V

21 Reviews

Part Number: WB44K10005

The bake element is located on the bottom of the oven with male spade terminals and push-on terminals. The bake element provides heat for baking. If your oven is too hot, not heating evenly, element is not heating, or little to no heat when baking, you may need to replace your bake element. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.

Oven Sensor

2 Reviews

Part Number: WB21X5301

The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace it. Make sure to disconnect the power to your range before starting your repair.

Burner Bowl - 6 Inch

Part Number: WB31K10265

This 6" chrome drip bowl is sold individually.

Chrome Burner Bowl - 8 Inch

1 Review

Part Number: WB31K10266

Broil Element - 240V

8 Reviews

Part Number: WB44K10002

This broil element is found on the roof of the oven.

Dual Radiant Element - 9 Inch

31 Reviews

Part Number: WB30T10133

The dual radiant element for your range or cooktop provides the heat that you cook with. It is found under the main cooktop. If your element will not heat, you will need to replace it with this part. This radiant element is 9 inches in diameter and is the larger of the two element sizes on your range. Be sure to disconnect your range from the power source before completing this repair. This radiant element is sold individually.

Burner Cap - Black - Medium - 9500 BTU

1 Review

Part Number: WB29K10023

The burner cap sits on top of the burner base and acts as a cover for the burner head. It helps protect the burner head from spills and helps spread the burner flame for even cooking. It is black in color and just over 3 inches in diameter. If your old burner cap is damaged or missing, this is the part that will replace it. This is an OEM part sourced directly from the manufacturer and is sold individually.

Burner Cap

3 Reviews

Part Number: WB29K10024

This is a burner cap for your gas range. The cap acts as a cover for the burner head. If your old burner cap is damaged or missing, this is the part that will replace it. The cap is black in color and about 3 and a half inches in diameter. This is a quality OEM part sourced directly from the manufacturer. This cap is sold individually.

Temperature Sensor

3 Reviews

Part Number: WB21X22134

The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.

Flat Style Oven Igniter Kit

9 Reviews

Part Number: WB13K21

The flat style oven igniter is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, then your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter please be very careful not to touch the black element part of the igniter as it is very fragile. The part measures approximately 3-3/4" in length and the amperage range is 3.3 to 3.6. The kit comes with a mounting bracket and a wire connector with a plug. *Please note: the connector plug might need to be removed and spliced to the range wiring using porcelain wire nuts. This is a genuine OEM part.