Inglis Trash Compactor Parts

Drive Gear Kit

5 Reviews

Part Number: 882699

This part is located at the bottom of your compactor and helps the drive motor power the compacting ram. If the drive gear is broken, damaged, or noisy, we suggest replacing it right away to avoid causing any more issues with your trash compactor. This kit includes the gears, washers, retainer clip, ram stop, and ram cam. This drive gear kit is a genuine OEM part, is white in color and made from plastic. Please remember to disconnect the power before starting your repair.

Nut

Part Number: WP776356

Sold individually.

Drawer Roller

Part Number: WP9871602

The drawer roller is used for your trash compactor. The roller attaches to the bottom of the lower frame to allow the container drawer to slide in and out easily. If the roller jams up, it can keep the drawer from opening correctly and you may need to replace the roller. This part measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Foot, Front - Single

Part Number: WPW10001130

The adjustable leveling leg is used to support and keep your washer level. It also allows you to adjust the height of your washer. If your washer is shaking, vibrating, or moving during operation you may need to replace this part. This part has a rubber foot, almost 3” long and is made of metal and rubber. This is a genuine OEM part and is sold individually.

Off-Switch Actuator Kit

1 Review

Part Number: W10342596

This kit contains the normally closed switch, toe guard, template, 2 screws and actuator. NOTE: This part has been redesigned by the manufacturer but will still function the same as the original part.

Wheel Assembly - Kit of 2

Part Number: 882688

The wheel assembly includes two wheels for your trash compactor. The wheels attach to the bottom of the lower frame to allow the container drawer to slide in and out easily. If the wheels jam up, causing the drawer not to open correctly, you may need to replace them. This is a genuine OEM kit.

Rotary Switch Kit

2 Reviews

Part Number: 675382

This rotary on/off switch kit comes with an on-off rotary switch and two chrome knobs. The switch is used to power the trash compactor. Once activated, the switch will send a voltage signal to the motor to start the compacting cycle. If your trach compactor won’t start or doesn’t stop at the end of the compacting cycle, the switch may need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to the trash compactor before starting your repair.

Cover, Air Freshener (Black)

Part Number: WP9871099

Black in color.

Power Nut Kit

Part Number: WP9870163

If your trash compactor ram gets stuck or does not stop at the end of the compacting cycle you may need to replace the power nut. The power nut is intended for use with trash compactors. This part is attached to the side of the ram where it is threaded. When the power screw rotates, it is fed through the power nut which pulls the ram down to compress the trash. This power nut is white in color and made from plastic. Please remember to disconnect the power to the trash compactor before starting your repair.