Jenn-Air Dryer Parts

Multi Rib Belt - 92-1/4"

66 Reviews

Part Number: 341241

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

M Series New Style Coil Kit

10 Reviews

Part Number: 279834

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Blower Wheel

8 Reviews

Part Number: W11497304

This genuine OEM white blower wheel has a deep D-shaped shaft receptacle, 7 1/8-inch hub diameter, 8-inch fin diameter, 1/2 -inch diameter motor shaft, 3 1/8-inch deep, 20 standard fins, 3/8-inch motor shaft diameter to flat side of the shaft. The blower wheel attaches to the drive motor shaft and blows the air through the drum and out through the exhaust. The spring clamp is not included with this part. Please be sure to disconnect the power to your dryer before starting your repair.

Heating Element Kit - 240V 4750W

4 Reviews

Part Number: LA-1044

This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.

Lint Duct Housing

1 Review

Part Number: 12001324

Does not include the seal

Dryer Radiant Flame Sensor

3 Reviews

Part Number: WP338906

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

Door Catch Kit

4 Reviews

Part Number: LA-1003

The door catch helps keep the door closed while the machine is running. If your dryer won’t start or the door won’t close you may need to replace the door catch. This is a genuine OEM part and includes both the male (strike) and female (catch) pieces. Please remember to disconnect the power to your dryer before you start the repair.

Cycling Thermostat

1 Review

Part Number: WP31001192

L146-25F 240 Volt internal heater. This thermostat helps to regulate the dryer's internal temperature.

Lint Filter

3 Reviews

Part Number: WP53-0918

The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This lint filter screen has two side guides on either of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide. This is a genuine OEM part.

Blower Wheel - B/10 Models

Part Number: 31001043

This blower wheel is suitable for some clothes dryers of the 10 and earlier series. Manufactured to fit a 1/2 inch motor shaft, this blower wheel is 3-1/8 inches deep. The diameter of the wheel is 7-1/8 inches, and the spring clamp is not included.