Hello!

You're visiting the Easy Appliance Parts site in Canada.

Would you like to shop on the U.S. site?

Go to U.S. site
Stay on this site

11076901690 Kenmore Dryer Parts List

Search the entire 11076901690 by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?
< PREV 1 2 3 4 5 6 ... 10
1-15 of 149

Dryer drum support roller (dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.)

The drum support roller has a metallic bearing in its center. This part is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, won’t tumble or takes too long to dry, you might need to replace the roller. It is recommended that you replace both rollers at once. This is a genuine OEM part and is sold individually. Please remember to shut off the power to the dryer before starting the repair.

Easy Part #:
EAP11752609
Availability:
In Stock
Price:
$26.06

Idler pulley (dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dr)

A dryer's idler pulley helps the belt to rotate the drum. It is also known as dryer belt tension pulley wheel.

Easy Part #:
EAP334244
Availability:
In Stock
Price:
$30.95

Door catch kit (dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.)

This door catch kit contains two door strikes and three door catches to service dryer doors that have one or two catches. Make sure to read the instructions to determine which one to use for your model. These parts keep the dryer door closed to allow the dryer to operate. If your door won't stay closed or will not start you may need to replace this part. This is a genuine OEM part.

Easy Part #:
EAP334230
Availability:
In Stock
Price:
$5.79

Lint filter (dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.)

This filter collects lint as it passes through the dryer vent.

Easy Part #:
EAP1491676
Availability:
In Stock
Price:
$70.60

Drive belt (dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves.)

This dryer drum belt has 4 ribs and 3 grooves. This belt is 1/4 of an inch wide. This drive belt is 93 1/2 inches long, and 1/4 of an inch wide, with 4 ribs and 3 grooves. To complete this repair, you will need a Phillips screw driver, a 1/4 inch nut driver, a putty knife, and a pair of needle nose pliers. Make sure to disconnect power to the dryer before beginning this repair.

Easy Part #:
EAP11722115
Availability:
In Stock
Price:
$25.21

Dryer cycling thermostat (dryer cycling thermostat with internal bias heater, l155-25.)

The cycling thermostat with an internal bias heater will continually cycle the heating element off and on to maintain a constant inner temperature in the dryer. This cycling thermostat has a limit of 155 degrees Fahrenheit and a differential of 25 degrees. Meaning that the heating element will cut out at 155 degrees and cycle back on once the internal temperature drops by 25 degrees. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.

Easy Part #:
EAP11741405
Availability:
In Stock
Price:
$32.13

Idler pulley with bracket (dryer idler pulley assembly.)

The idler pulley wheel is now sold with this arm. This idler pulley is for dryers. Idler pulley maintains correct tension on the drive belt to spin the drum.

Easy Part #:
EAP11726337
Availability:
In Stock
Price:
$30.77

Dryer drum seal with adhesive (dryer drum felt seal kit. Includes silicone rubber adhesive.)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Easy Part #:
EAP970088
Availability:
In Stock
Price:
$54.30

Moisture sensor (dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dr)

This is the moisture sensor for your dryer. It helps detect the amount of moisture in your clothes during the dryer cycle. If you notice your clothes are still wet after an automatic dryer cycle is done, you may need to replace the sensor. You will find the moisture sensor behind the lint screen. Be sure to disconnect the power source from the dryer before you begin this repair. Note: Some model's require two sensors, please order quantity needed. Sensor only, harness is not included. This part is sold individually.

Easy Part #:
EAP11741408
Availability:
In Stock
Price:
$11.97

Light bulb - 10w (light bulb, 10 watt.)

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Easy Part #:
EAP11739347
Availability:
In Stock
Price:
$18.75

Touch-up paint - white (white touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Easy Part #:
EAP385132
Availability:
In Stock
Price:
$9.19

Blower wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Easy Part #:
EAP11743811
Availability:
In Stock
Price:
$81.58

Dryer radiant flame sensor (gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly.)

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

Easy Part #:
EAP11741429
Availability:
In Stock
Price:
$55.03

Disposable thermal fuse - two terminal (dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to)

This part attaches to the exhaust duct of your clothes dryer.

Easy Part #:
EAP11741444
Availability:
In Stock
Price:
$20.64

Lid switch (dryer door/washer lid switch kit)

The door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open. The dryer cannot operate until the door switch signals that the door is closed. If your dryer won’t start or the switch shorted out, your washer will not operate and the switch will need to be replaced. This switch is a genuine OEM part. Please remember to disconnect power to the dryer before starting the repair.

Easy Part #:
EAP11723153
Availability:
In Stock
Price:
$27.21
< PREV 1 2 3 4 5 6 ... 10
1-15 of 149