Most Popular Parts
These are the most commonly purchased repair parts for ADG4BRGS111TW01.
-
This screw is sold individually.
-
(10)
This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(1)
This part replaces older two terminal switches.
-
The felt seal keeps the hot air in the dryer drum. It is located between the back of the drum and the rear dryer panel. If your dryer is noisy, or the seal is damaged, you will need to replace it. This is the seal only; the high temperature adhesive is not included. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.
-
This spring retaining clip is used to hold the front panel onto the top of the washer. If your front panel is loose you might need to replace the clip. The clip is made entirely of metal and is used for some washing machines. This part is not quite an inch long and is sold individually. This is a genuine OEM part.
-
This tapping screw is sold individually.