Washer Parts

Washing Machine Drain Pump

24 Reviews

Part Number: 4681EA2001T

This drain pump motor helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. If your washer will not drain, is noisy, leaking, or pumps but will not spin, you may need to replace the drain pump motor. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. Note: Pump casing is not included.

Washer Door Boot Seal

20 Reviews

Part Number: 5304505004

This is a door boot, also known as a door gasket or door bellows, for various models of washing machines. This door boot is used to seal the inner drum of the washing machine from the inside of the washing machine cabinet, and the outside of the appliance itself. If you are noticing soap or water leaks, or if the inner drum of your washer is significantly loose and/or showing signs of tearing, this boot will need to be replaced. To remove this boot, you will need a set of pliers to remove its clamp. This boot is sold as an individual OEM part, so any necessary clamps or parts to secure it are sold separately.

Drain Pump

27 Reviews

Part Number: WPW10605427

Dryer Lint Filter

8 Reviews

Part Number: 5231EL1003B

The lint filter has a felt strip and is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This is a genuine OEM part.

Magnetic Door Plunger

Part Number: AGM73610701

The magnetic door plunger attaches to the inner door panel of your washer and will hold the door open when the washer is not in use and allows the door and tub seal to dry. By doing this it will prevent mold and mildew buildup around your door and seal. If your washer door will not close you many need to replace this part. The magnetic door plunger is a genuine OEM part.

LATCH

9 Reviews

Part Number: 5304505088

Washer Drain Pump Assembly

2 Reviews

Part Number: 5859EA1004P

This drain pump is for washers. Drain pump removes water from the washer during the drain portion of the cycle. Unplug the washer before installing this part. Wear work gloves to protect your hands.

Washer Water Inlet Valve

1 Review

Part Number: AJU75152601

This is an authentic LG water inlet valve for a top-load washer. It is designed to control the flow of water into the washer. If your washer is filling slowly, making loud noises, overflowing, or stopping in the middle of a cycle, you may need to replace the water inlet valve. Be sure to disconnect the power and water supply before you begin this repair.

Water Inlet Valve - Hot

2 Reviews

Part Number: 5220FR2006H

The hot water inlet valve is located on the back of the washer and it helps control the amount of water that enters into the washer. The valve has a standard hose fitting inlet, 1 water outlet, 120 volts and 6 watts. If the washer is filling slowly or not at all, the solenoid may have gone bad and you will need to replace the inlet valve. The valve measures approximately 3” L x 2 3/4” W. Please remember to disconnect the water and power to the washer before starting the repair. This is a genuine OEM hot water inlet valve.

Washing Machine Suspension Rod Kit

25 Reviews

Part Number: W10780048