Most Popular Parts
These are the most commonly purchased repair parts for IK8 (M-1).
-
(10)
The ice maker assembly is used to produce ice for your refrigerator. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold into the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. This kit includes the fill cup, 4 pin wire harness adapter, and tube. Please remember to disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.
-
The cycling thermostat controls the activation of the icemaker ejection cycle.
-
(1)
This ice maker is the replacement heat-release unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors. This is a genuine OEM part. Please make sure you disconnect the power to the refrigerator before starting your repair.
-
-
This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.
-
The ice ejector bar is made of plastic, white in color, and is used to push the ice cubes from the ice maker into the ice bin. The bar measures approximately 9 inches long. If the ejector bar becomes broken or ice is not entering into the bin, you may need to replace the part. This is a genuine OEM part. Please make sure you disconnect the power and water supply to the refrigerator before starting your repair.