Roper Dishwasher Parts

Rack Track Stop

31 Reviews

Part Number: WP8565925

This gray rack track stop is used for your upper dish rack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.

Dishwasher Heating Element

27 Reviews

Part Number: W10518394

The heating element is used to create heat during the dry cycle and increase water temperature during portions of the wash cycle when certain options are selected. If your dishes are not drying or the water in the dishwasher is not getting hot you may need to replace the element. This kit includes the heater, two heater fasteners, and is a genuine OEM part. Please remember to disconnect the power before starting the repair.

Friction Sleeve

10 Reviews

Part Number: WP8268961

The friction sleeve helps to reduce friction between the door hinge and the door and to keep your door quiet when it opens and closes. This part is a little over an inch long and is black in color. It is sold individually.

Chopper Assembly

21 Reviews

Part Number: W10083957

This chopper assembly chops up/mince the food particles to prevent from clogging the dishwasher pump.

Dishwasher Drain Pump

37 Reviews

Part Number: WPW10348269

Water Inlet Valve

33 Reviews

Part Number: WPW10158389

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Drain Hose

9 Reviews

Part Number: WPW10545278

This part is used to drain water from your dishwasher.

Circulation Pump and Motor

26 Reviews

Part Number: WPW10757217

The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.

Accumulator and Filter

5 Reviews

Part Number: 8193918

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Mounting Bracket

1 Review

Part Number: WP8269145

The mounting bracket is used to attach the dishwasher to the underside of the counter. The mounting bracket holds the dishwasher in place to keep it from moving during cycles and to keep the dishwasher level. The bracket is made of metal and is approximately 3” in length. The screws are not included with the bracket, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the dishwasher before starting the repair.