Most Popular Parts
These are the most commonly purchased repair parts for 3XART731GB02.
-
(35)
This clear crisper drawer with humidity control allows you to adjust the humidity within the crisper. This can extend the life of your produce. Does the drawer measure approximately 7.60 inches in height by 14.92 inches from front to back and 16.50 inches wide. This is a genuine OEM part.
-
(15)
This clear convertible meat drawer can be used to store meats or vegetables. It has its own cold air duct to allow cold air from the freezer to flow into the drawer. You could have a broken or faulty drawer if you find that the food being kept within is spoiling or drying out quickly. The drawer should slide open and closed with ease. If your drawer will not easily slide open or closed, check the tracks that the drawer slides on. If the tracks are not damaged, the drawer itself could be at fault and should be replaced. This part measures approximately 16 7/16 inches wide x 14 5/16 inches deep x 7 5/8 inches high, and is a genuine OEM replacement part. It is sold individually.
-
(4)
This part is also known as a shelf frame. This drawer cover is for refrigerators.
Drawer cover has rail brackets under the cover that hold the drawer and allow the drawer to slide in and out on the rails.
Follow the instructions in the owner's manual or installation guide when installing this part. This comes with glass.
-
(1)
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.
-
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.
-
(7)
This ice door is used to seal off the ice chute when not in use. When in use the door will open in the dispenser chute to allow ice to be dispensed. This kit includes the ice door, support, spring, and delay. The heater ribbon is no longer attached. The heater is no longer needed due to an authorized update from the manufacturer. If your ice maker won’t dispense ice or frost build up you may need to replace the part. Please remember to disconnect the power to the refrigerator before starting your repair.