Most Popular Parts
These are the most commonly purchased repair parts for 62945766.
-
(14)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.
-
(18)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(1)
-
(5)
This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.
-
(9)
This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch:
1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2).
2) Do not connect the pilot lamp (P) wire yet.
3) Reconnect the power to the range and turn on the new switch and one other switch.
4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on.
5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed.
6) Disconnect power, reverse Line Wires if needed and connect the P wire.
7) Reconnect power to the range after reassembly.
-
Each hinge is sold seperately.