Most Popular Parts
These are the most commonly purchased repair parts for 7DU920PWKS0.
-
(32)
This gray rack track stop is used for your upper dish rack track to prevent the rack from sliding off the slide rail. If your rack is falling off the track, you may need to replace the track stop. This is a genuine OEM part and is sold individually.
-
(9)
If your dishwasher is leaking during use you may need to replace the gasket. The door gasket wraps around the sides and top of the dishwasher door and provides a waterproof seal between the tub and the door. It is gray in color and made of rubber. Once you have installed the door gasket it is recommend to close the dishwasher door and leave it closed for a few hours to make sure the door gasket properly seals. This is a genuine OEM part.
-
(6)
Sold Individually.
-
This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.
-
(5)
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. NOTE: As per the manufacture this part has been updated from the original part. It may be a different color, and you may need to order an elbow (# W10685193) for the new designed valve to work.
-
(1)
This track attaches to the inside of the tub for the upper rack to glide in and out.