Most Popular Parts
These are the most commonly purchased repair parts for ACS3350AB.
-
(4)
These pads go on the bottom of your gas cooktop grates to prevent them from moving and scratching the top of your appliance.
-
(6)
This part is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter, be very careful not to touch the black element part of the igniter as it is very fragile. You will need to reuse the original bracket when installing the new igniter.
-
This screw is sold individually.
-
(1)
This top burner igniter is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start or the gas igniter glows but will not light, you may need to replace the igniter. This top burner igniter is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.
-
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2" x 12-3/4" x 16-3/4" and is a genuine OEM part.
-
(1)
The oven door hinge assembly attaches to the right side of the door allowing the oven door to open, close, and stay open at an angle. If your oven door is not working properly then you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures approximately 11 1/2” long, is made of metal, includes a spring and two screws. This is a genuine OEM part.