Whirlpool Dehumidifier AD40DSL1
Repairing your AD40DSL1 Whirlpool Dehumidifier is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
AD40DSL1 model diagrams below. Trust us to help you find the part you need and get your
AD40DSL1 Whirlpool Dehumidifier running again.
Diagrams for Whirlpool AD40DSL1 Dehumidifier
There are 3 diagrams for AD40DSL1. Click on the diagram where you think your part is located.
Most Popular AD40DSL1 Parts
These are the most commonly purchased repair parts for AD40DSL1.
-
-
The float is used to help monitor the water level inside of the dehumidifier bucket to prevent water from overflowing onto the floor. Once the water level reaches the maximum in the bucket, the float will signal the float switch to shut down the dehumidifier to avoid the bucket from overflowing, causing water to spill on to your floor. If your bucket is overflowing you may need to replace the float. The float is black in color, made of plastic and measures approximately 4” long. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.
-
Sold individually.
-
This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.
-
Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".
-