Most Popular Parts
These are the most commonly purchased repair parts for ADE20L1H.
-
This screw is sold individually.
-
(4)
This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.
-
(1)
This is the replacement motor pulley for your dryer. The motor pulley transfers momentum from the drive motor to the drum via the drive belt. If the motor pulley cracks or is no longer staying on the drive shaft, you will need to replace it. You will need to access the dryer motor for this repair, by removing the front panel. The motor pulley is approximately 1 inch in diameter and is sold individually. This is an OEM part sourced directly from the manufacturer.
-
(1)
Does not include the seal
-
(4)
This part is the replacement thermal fuse for your dryer. It measures a little more than an inch wide, and about ¾ inch long. The thermal fuse is a safety device that shuts off the burner in a gas dryer, or the motor in an electric dryer when the dryer overheats. If your dryer will not start, or if it is not producing any heat, you may need to replace the thermal fuse. Be sure to disconnect power to the dryer before you begin this repair. This part is sold individually and is an authentic OEM part sourced from the manufacturer.
-
This clamp is used to secure the drive motor.