Admiral Dryer ADG20K2H Sections

There are 3 diagrams for ADG20K2H. Click on the diagram where you think your part is located.

CONTROL PANEL (REV. E)

CYLINDER & DRIVE (REV. E)

GAS CARRYING (REV. E)

Most Popular Parts

These are the most commonly purchased repair parts for ADG20K2H.

Multi Rib Belt - 92-1/4"

CAD$19.75

In Stock

(66)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
M Series New Style Coil Kit

CAD$35.48

In Stock

(10)

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
Screw, 8/18 x 3/8

CAD$6.22

In Stock

This screw is sold individually.
Clamp-Motor

CAD$12.78

In Stock

This clamp is used to secure the drive motor.
Lint Duct Housing

CAD$145.07

Special Order

(1)

Does not include the seal
Dryer Radiant Flame Sensor

CAD$55.03

In Stock

(3)

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.