Most Popular Parts
These are the most commonly purchased repair parts for ARG7600LL.
-
(6)
This part is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter, be very careful not to touch the black element part of the igniter as it is very fragile. You will need to reuse the original bracket when installing the new igniter.
-
This screw is sold individually.
-
(4)
The temperature sensor detects the temperature within the oven cavity and sends the information to the electronic control board. If your oven is too hot or not getting to the correct temperature, you may need to replace the sensor. This part has a body length of just over three inches and is a genuine OEM part. Please remember to disconnect the power to the oven before starting your repair.
-
(1)
The oven light provides light in the oven cavity. The light assembly is a little over four inches long and has a 660-watt light bulb. If the light is not turning on, the bulb may be burnt out or the socket has failed and will need to be replaced. This is a genuine OEM part.
-
(1)
This top burner igniter is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start or the gas igniter glows but will not light, you may need to replace the igniter. This top burner igniter is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.
-
The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2" x 12-3/4" x 16-3/4" and is a genuine OEM part.