Most Popular Parts
These are the most commonly purchased repair parts for BIS42AJC.
-
This part comes with 3 round pin connection terminals.
This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.
-
The ice maker water line is used to direct and supply water to the ice maker during the fill cycle. This waterline is located on the back wall of your refrigerator/freezer, is made of plastic and is 1/4” in diameter. If the water line becomes damaged it could cause water to leak on the floor and the tubing will need to be replaced. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.
-
-
This rear wheel is sold individually. The wheel pin is not included with this roller.
-
This defrost thermostat kit comes with the installation with wires, mounting brackets, and wire connectors. L45-20.
-
When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker is not making/dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall and make sure to disconnect both the water and power supply before starting your repair. As per the manufacturer, this valve has a new quick connection. You must cut the retaining nut off your current plastic water line, and gently push it into the new valve.