Most Popular Parts
These are the most commonly purchased repair parts for CAWS729MQ1.
-
(12)
The clutch assembly is used on direct drive washing machines and helps spin the basket during the spin cycle to remove water from the tub. If your clutch is worn out it can cause the washer to be noisy or leave water in the tub because it won’t drain properly, which will leave your clothes soaked. The clutch assembly includes a brake cam driver, retaining ring, bearing, and a spring, depending on your model number. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the washer before starting your repair.
-
(9)
This pump is intended for use with washing machines that do not have belts. This drain pump has two ports for water to pass through: a large one, and a smaller one. This part is used to remove water from the tub during the drain cycle. If your washer is leaking, not draining, pumps but will not spin or fills and drains at the same time you may need to replace the pump. The pump is located on the motor and is attached by two clips. This part is white in color, made from plastic and is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(11)
This is a replacement lid switch for your washer. The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.
-
(5)
This is not the full agitator assembly. This is just the agitator base.
-
This part gets the motor up to speed quickly before transferring power to the run capacitor.
-
(2)
The drum is driven directly by the motor, replacing the usual belt or gearbox-driven system which increases efficiency and decreases noise. NOTE: The cardboard is not included with this part.