Most Popular Parts
These are the most commonly purchased repair parts for CSCP5UGXDFSS.
-
(4)
This part is located in the front of the module shelf.
-
(4)
The temperature sensor, also known as a thermistor, helps detect the temperature inside the refrigerator and sends the information to the control board. If your refrigerator is too warm or not cooling properly, you may need to replace the temperature sensor. This is a genuine OEM part. Please make sure to disconnect the power to the refrigerator before starting your repair.
-
(1)
This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.
-
This is the replacement evaporator drip pan, also known as the drain trough, for your refrigerator. You will find the drip pan in the fresh food section of the refrigerator. It collects any water that may drip off the evaporator. If your drip pan is rusted, or is leaking into the refrigerator, you may need to replace it. Before you install the new drip pan, you will want to thoroughly clean the areas around the evaporator to ensure there is no more remaining rust or debris. This part is sold individually and is an OEM part sourced directly from the manufacturer.
-
-
This OEM water filter works with side-by-side and bottom freezer refrigerators. You will find this filter mounted in a vertical position in the back upper right-hand corner of the refrigerator compartment. If your model does not have an indicator light, remember to use the month and year stickers on the new cartridge to remind yourself to replace it in another 6 months. Replacement timelines can vary according to your local water conditions. To install the new filter, you will first match the threads with the corresponding threads on the holder. Position the top of the new cartridge up into the holder without pushing it upward. Carefully turn it to the right until it will no longer turn. Make sure you run water through the dispenser right after installation. This clears the system and prevents sputtering. If you have an LCD model, press the Filter Replaced button to reset. If you have a non-LCD model, press and hold the Reset Water Filter button on the dispenser for a few seconds. This filter filters down to 0.5-1 microns. The lower the micron the more toxins are caught and lessened.