Most Popular Parts
These are the most commonly purchased repair parts for EWMGD65IMB2.
-
(3)
-
-
The high temperature adhesive is used to create a heat resistant bond between felt seals and rubber gaskets on your appliance. This adhesive is made to withstand hot temperatures. This tube contains one ounce of adhesive. Before starting your repair, it is recommended to wear gloves and ensure that your working area is clean and dry.
-
(1)
-
(2)
This non-reset-able flush mounted thermal fuse shuts off the power to the motor if the dryer over heats. If the fuse is blown you will need to replace it since it can not be reset. The thermal fuse mounts on to the vent tube. Please remember to disconnect the power before starting the repair. This is a genuine OEM part.
-
(2)
The gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If it takes too long to dry or there is no heat, the coils may be bad and will need to be replaced. When the coils go bad they won’t hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.