Most Popular Parts
These are the most commonly purchased repair parts for FLSC238DS7.
-
(13)
When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker is not making or dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall. Make sure to disconnect both the water and power supply before starting your repair. NOTE: This part may appear different than the original but is an authorized manufacturer replacement.
-
(3)
This crisper cover support mounts to the inside of the cabinet wall to support the front crisper cover. The support is held in place by a locking pin. If your shelf is not level or the drawer is not opening and closing properly you may need to replace this part. This is a genuine OEM part and is sold individually
-
The evaporator fan motor is in the back of the freezer section and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. It is suggested to replace the thermistor when replacing the evaporator fan. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.
-
(6)
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.
-
(2)
This is a replacement crisper glass insert for your refrigerator. It fits into the crisper pan frame and acts as the top of the crisper pan, as well as a shelf for food storage. Because it is made of glass, the insert can occasionally become cracked or broken, and in this case, it will need to be replaced. To replace the insert, simply slide the old insert out and replace it with the new one. The glass insert measures approximately 17.12" X 15.40", and is sold individually. This is an OEM part sourced directly from the manufacturer.
-
(2)
Glass insert must be ordered separately.