Most Popular Parts
These are the most commonly purchased repair parts for FRT17G4BW0.
-
(35)
This drawer slide rail is for the right-hand side of your refrigerator. This part attaches to the inside wall of your refrigerator to support the sliding crisper drawer. If the rail is broken or the drawer is not sliding properly, you will need to replace the slide rail. You will need a Phillips screwdriver to complete this repair. This drawer slide rail is a genuine OEM part.
-
(11)
This drawer rail supports the left hand side of the sliding drawer.
-
(3)
This is the replacement meat pan for your refrigerator. It is made of clear plastic and is approximately 18 inches long and 13 inches wide. The meat pan slides into the bottom of the refrigerator shelf and is used to store meat and other food items. The main reason to replace the meat pan is if yours is cracked, damaged, or missing. To replace the meat pan, simply slide the old pan out, and slide the new one into place. This part is an OEM part sourced directly from the manufacturer, and is sold individually.
-
(6)
This 60Hz 120V defrost timer will cycle for thirty minutes after every eight hours of run time. You can turn the dial on the defrost timer clockwise to be able to advance it in and out of defrost mode. The defrost timer helps melt away any ice that may have built up on the evaporator coils. If your refrigerator/freezer is too warm or too cold, won’t advance into the defrost cycle, freezer won’t defrost, or it runs too long, the defrost timer may be defective and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.
-
(3)
This cold control thermostat cycles on and off regularly to keep your refrigerator cold.
-
(2)
This is the replacement crisper pan cover for your refrigerator. It is made of white plastic and measures approximately 26 inches wide and 19 inches long. The crisper cover fits on top of the crisper pan, and acts as a shelf to store items on top of the crisper. The main reason you would want to replace the crisper cover pan would be if the previous cover pan was cracked, damaged or missing. To replace the crisper pan cover, simply slide the old cover out, and replace it with the new one. This part is sold individually and is an OEM part from the manufacturer.