Most Popular Parts
These are the most commonly purchased repair parts for FWX6975E.
-
(10)
The control knob is used to control the cycles for your dryer. This knob is white in color, made of plastic, 1 1/2” in diameter and accepts a D-shaped shaft. If the part is damaged, missing, or if the shaft is cracked, keeping you from turning the switch, you may need to replace the knob. This is a genuine OEM part and is sold individually.
-
This drive belt is designed to ride on the pulley until the basket gets up to speed. If your washer drum won’t agitate or spin, you may need to replace your belt. It is recommended to disconnect the power to your washer and shut off the water supply before you start your repair. This drive belt is a genuine OEM part.
-
(5)
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed. If your washer will not stop filling with water, is leaking, or will not fill with water, you may need to replace the water inlet valve. Please make sure to disconnect the power to your washer before you start your repair. This water inlet valve is a genuine OEM part.
-
(3)
This tub seal helps prevent any leaking around the transmission of your washer. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(3)
Use this with either a top load or front load washer. This pump has an horizontal mount.
-
(1)
This part comes with a ninety degree elbow.