Most Popular Parts
These are the most commonly purchased repair parts for GTS18KHPARWW.
-
This part acts as a safety device against over-heating in case of mechanical failure.
-
Also known as Heater Conduction.
-
(1)
This OEM filter is sold individually. Change your filter every 6 months for the best results. This filter is found in top-freezer and bottom-freezer refrigerators located in the back upper right corner. It measures 4.75-Inches deep, 9.5-Inches high, and 5.25-Inches wide. It is certified to reduce particles, chlorine-resistant cysts, lead and five other impurities. The pressure requirement is 40-120 PSI (if yours exceeds this, you?ll need to install a pressure-timing valve), and the operating temperature needs to be 33-100 degrees Fahrenheit. It filters down to 0.5-1 microns.
The installation is simple and does not require any tools or mess. To remove the old cartridge, turn it to the left and pull down carefully. Some water might drip, so keep a cloth handy. To install the new filter, place it into the cartridge holder and turn to the right until it will no longer turn. If you have a top-freezer model it should be situated vertically, and if it is a bottom-freezer model, it should be placed horizontally. Be careful not to over-tighten. If your model has a replacement indicator light, reset it by pushing and holding it down for three seconds. If your model has a dispenser, run water through it for approximately 3 minutes to clear the system. Please note that this filter will not work in Kenmore brand models.
-
This snack pan slide rail, also known as a drawer slide rail, is a genuine OEM replacement part for your refrigerator. This slide rail is white in color, and serves to help your snack pan slide in and out of the refrigerator with ease. It can become cracked or broken over time and need replacing. This is a very easy repair, to complete it you simply need to remove the snack pan, uninstall the current slide rail and affix the new one in place.
-
(3)
This condenser fan motor is made for a refrigerator. The motor powers your fan to circulate air to the condenser coil. The condenser coil removes heat from the refrigerant gas. The motor base measures about 2.5 by 2.5 inches, and features a 3-wire connector. This part does not include the fan, please consider ordering that part separately if necessary.
-
(3)
This part is the replacement snack pan slide rail for your refrigerator. It is made of white plastic and is approximately 16 inches by 2 inches. The crisper draw will slide in and out along this rail. If the rail is damaged or missing, the crisper will either hang from one side, or it will not stay in place at all. The drawer slide rail is for the left side of the drawer only, so be sure to check that you are replacing the correct drawer rail. This part is sold individually and is an OEM part sourced directly from the manufacturer.