Most Popular Parts
These are the most commonly purchased repair parts for GTS18KHPKRWW.
-
(1)
The evaporator fan motor grommet provides a cushion between the fan motor and the motor mounting bracket. This part is made of black plastic and is approximately one inch in diameter. If your grommet is torn or damaged and you are getting noise from the fan motor, you may need to replace it. This is an OEM part sourced directly from the manufacturer. Please remember to disconnect the power to the refrigerator before starting your repair.
-
(1)
This part acts as a safety device against over-heating in case of mechanical failure.
-
(3)
This is the replacement vegetable pan cover for your refrigerator. It is made of white plastic and measures approximately 26 inches by 18 inches. This part is the frame of the pan only, and does not include the glass that forms the shelf. The vegetable pan lid is found at the top of the vegetable pan and acts as a frame for the pan. This part is sold individually and is an OEM part sourced directly from the manufacturer.
-
This part acts as a safety device against over-heating in case of mechanical failure.
-
Also known as Heater Conduction.
-
(1)
This OEM filter is sold individually. Change your filter every 6 months for the best results. This filter is found in top-freezer and bottom-freezer refrigerators located in the back upper right corner. It measures 4.75-Inches deep, 9.5-Inches high, and 5.25-Inches wide. It is certified to reduce particles, chlorine-resistant cysts, lead and five other impurities. The pressure requirement is 40-120 PSI (if yours exceeds this, you?ll need to install a pressure-timing valve), and the operating temperature needs to be 33-100 degrees Fahrenheit. It filters down to 0.5-1 microns.
The installation is simple and does not require any tools or mess. To remove the old cartridge, turn it to the left and pull down carefully. Some water might drip, so keep a cloth handy. To install the new filter, place it into the cartridge holder and turn to the right until it will no longer turn. If you have a top-freezer model it should be situated vertically, and if it is a bottom-freezer model, it should be placed horizontally. Be careful not to over-tighten. If your model has a replacement indicator light, reset it by pushing and holding it down for three seconds. If your model has a dispenser, run water through it for approximately 3 minutes to clear the system. Please note that this filter will not work in Kenmore brand models.