Amana Ice Maker IC3K
Repairing your IC3K Amana Ice Maker is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
IC3K model diagrams below. Trust us to help you find the part you need and get your
IC3K Amana Ice Maker running again.
Diagrams for Amana IC3K Ice Maker
There are 1 diagrams for IC3K. Click on the diagram where you think your part is located.
Most Popular IC3K Parts
These are the most commonly purchased repair parts for IC3K.
-
(2)
The ice bucket is used to hold the ice cubes in the freezer section that are released from the ice maker until ready to be used. If the bin becomes lost or damaged, you will need to replace the bin. The bin is white in color, made of plastic, and measures approximately 15” x 12”. This is a genuine OEM part.
-
When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker isn’t making/dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall. Make sure to disconnect both the water and power supply before starting your repair. The manufacturer has redesigned the valve; it may appear different than the original. The updated valve has a new quick connection. To install the updated valve, cut the retaining nut off the existing water line and gently push into the new valve. This is a genuine OEM part. Please remember to disconnect the power and the water supply before starting your repair.
-
This single ¼” compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.
-
This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.
-
The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.