Most Popular Parts
These are the most commonly purchased repair parts for JHP62GN1.
-
(3)
This broil element is found on the roof of the oven and has push-on terminals.
-
The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
-
This hinge is located on each side of the oven door
-
The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
The terminal block clip is used to support and secure the burner element receptacle to the cooktop. This part is made of metal and almost 2 1/2” long. The clip is sold individually, terminal block is not included clip only. This is a genuine OEM part. Please remember to disconnect the power to your range before starting your repair.
-
Sold Individually.