Most Popular Parts
These are the most commonly purchased repair parts for LER3330AAZ.
-
(14)
The oven door gasket prevents heat from escaping the oven cavity when in use by creating a seal around the oven door. If your oven has little or no heat when baking, you may need to replace the gasket. This door gasket contains all the attaching clips needed for installation and is a genuine OEM part. Please make sure the oven is cool before installing the door gasket.
-
(14)
The interior oven door glass is the innermost heat resistant piece of glass that faces in your oven. The see-through glass measures approximately 20 5/8” x 13 1/8”. If the glass is cracked it should be replaced. When replacing the interior door glass please wear gloves to protect your hands in case the glass breaks and do the repair when the door glass is cool to touch. This is a genuine OEM part and is sold separately.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(23)
This 6 inch 1200-watt radiant surface element with limiter is located under the main cooktop. When the element is turned on, it will heat up and provide heat to the cooking area on top of the range. If your element will not supply heat you will need to replace it. When replacing the radiant surface element please make sure the element is cool to touch before starting the repair. Disconnect the power to your range before beginning the repair. This is a genuine OEM part.
-
(4)
This broil element is found on the roof of the oven.
-
(9)
This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch:
1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2).
2) Do not connect the pilot lamp (P) wire yet.
3) Reconnect the power to the range and turn on the new switch and one other switch.
4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on.
5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed.
6) Disconnect power, reverse Line Wires if needed and connect the P wire.
7) Reconnect power to the range after reassembly.