Most Popular Parts
These are the most commonly purchased repair parts for MAH22PRAWW0.
-
(51)
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. It has two ports for water to pass through: a large one, and a smaller one. If your washer will not drain, is noisy, leaking, or pumps but will not spin you may need to replace the pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. This pump also comes with a removable filter.
-
(4)
-
(2)
This part regulates the temperature of the water in the tub. The sensor is located in the heating element.
-
(8)
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature or amount of water needed.
-
(11)
This is a replacement tub-to-pump hose for your washer. This hose runs from the bottom of the tub to the water pump, and is used to transport water. The hose can develop a hole, and when this happens you will notice water leaking onto the floor. The tub-to-pump hose is found below the washer tub. To disconnect the hose, you will need to release the clamps that hold it in place with a pair of pliers. When you replace the tub hose, you will need to transfer the ball, air chamber, and clamps from the old pump to the new one. To do this, you will need a set of wire cutters and a new zip tie to replace the one you will need to cut.
-
(8)
This dispenser hose is for washers and carries the contents of the dispenser drawer to the washer tub.