Most Popular Parts
These are the most commonly purchased repair parts for MER4530AAW.
-
(7)
The surface burner terminal block kit includes one plastic block, metal bracket, wires, and high-temperature nuts. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This part is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(18)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(4)
This broil element is found on the roof of the oven.
-
(5)
This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.
-
(21)
This genuine OEM bake element has push-on terminal ends and provides heat while baking. If the bake element has arcing, is shorted out, the oven is not heating evenly, or little or no heat when baking, you may need to replace it. When replacing the bake element please make sure you disconnect the power to the range. Make sure you don’t let the wires fall back through the rear of the oven. This element has been updated by the manufacturer. New installation screws are required and are sold separately.