Most Popular Parts
These are the most commonly purchased repair parts for MEW6627DDS.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(18)
This 40-watt light bulb has a standard screw-in base. It is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(10)
The door hinge attaches to the side of the door allowing the oven door to open, close, and stay open at an angle. If your door is not opening and closing correctly you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures 20 ½” and is made of metal. This is a genuine OEM part.
-
This gasket prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.
-
The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.
-
(7)
This part is the oven bulb lens cover. It is made of glass and is approximately 3 inches in diameter. The lens cover protects the light bulb from being damaged. The main reason to replace the light lens cover is if it is cracked, damaged, or missing. Be sure that the lens cover is cool to the touch before you begin this repair. To remove the lens cover, simply turn it counter clockwise until you can remove it. Replace it with a new cover and turn it clockwise to lock it into place. This is an OEM part sourced from the manufacturer, and it is sold individually.