Most Popular Parts
These are the most commonly purchased repair parts for NDG7800AWW.
-
(10)
This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two-terminal secondary coil. If there is no heat or your drying time is getting longer, the coils may be bad and will need to be replaced. Once the coils go bad they do not hold the gas valve open properly. Usually only one of them burns out but you should replace them as a set. Both must be operational for the gas valve to open. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
(8)
This dryer drum belt has five ridges, 93-3/8" inches in length, and 3/8 of an inch wide. It is flat, black in color, and is made entirely of rubber. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
-
This single drum support roller is used for square-ported model clothes dryers. It has a metallic bearing in its center. This support roller is used to hold the drum in place in the cabinet while letting the drum rotate on the support rollers. If your dryer is noisy, will not tumble, or takes too long to dry, you might need to replace the roller. It is recommended that you replace both rollers at once. It is sold individually.
-
(1)
Part may differ in appearance, but functions same as original part.
-
(1)
This part replaces older two terminal switches.
-
The felt seal keeps the hot air in the dryer drum. It is located between the back of the drum and the rear dryer panel. If your dryer is noisy, or the seal is damaged, you will need to replace it. This is the seal only; the high temperature adhesive is not included. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.