Most Popular Parts
These are the most commonly purchased repair parts for PER5750QCQ.
-
(56)
The large surface element is installed under the cooktop and heats up the area directly above it. It is approximately 10 inches in diameter and is 1200/2500 watts. If your element is not heating up, you may need to replace the element or check the burner switch. This part a genuine OEM part. Please remember to disconnect the power to your range before starting your repair.
-
(18)
This bake element is found on the bottom of the oven. This bake element is for ranges.
The bake element is at the bottom of the oven and supplies the heat for baking.
Unplug the range or shut off the house circuit breaker before installing the part
-
(14)
The interior oven door glass is the innermost heat resistant piece of glass that faces in your oven. The see-through glass measures approximately 20 5/8” x 13 1/8”. If the glass is cracked it should be replaced. When replacing the interior door glass please wear gloves to protect your hands in case the glass breaks and do the repair when the door glass is cool to touch. This is a genuine OEM part and is sold separately.
-
(5)
This oven door gasket prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.
-
(4)
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
(23)
This 6 inch 1200-watt radiant surface element with limiter is located under the main cooktop. When the element is turned on, it will heat up and provide heat to the cooking area on top of the range. If your element will not supply heat you will need to replace it. When replacing the radiant surface element please make sure the element is cool to touch before starting the repair. Disconnect the power to your range before beginning the repair. This is a genuine OEM part.