Most Popular Parts
These are the most commonly purchased repair parts for RB755GN4AD.
-
(3)
This broil element is found on the roof of the oven and has push-on terminals.
-
The support clip is used to hold the broil element in place at the top of the oven cavity. If the clip is broken or damaged, you will need to replace the part. The support clip is made of metal, is a little over an inch long, and is sold individually. This is a genuine OEM part.
-
This hinge is located on each side of the oven door
-
The surface burner terminal block kit comes with a terminal block, wire nuts, heat shrink protective tubing, and wires. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
Sold Individually.
-
The surface element control switch turns the surface element on and off and controls how much heat the element produces. (1500W)