Most Popular Parts
These are the most commonly purchased repair parts for RD50CBM4.
-
Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".
-
-
The float is used to help monitor the water level inside of the dehumidifier bucket to prevent water from overflowing onto the floor. Once the water level reaches the maximum in the bucket, the float will signal the float switch to shut down the dehumidifier to avoid the bucket from overflowing, causing water to spill on to your floor. If your bucket is overflowing you may need to replace the float. The float is black in color, made of plastic and measures approximately 4” long. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.
-
The protector overload attaches to the compressor to help start the compressor motor and then shuts off as soon as the motor gets up to speed. The overload is black in color and measures approximately 3”. If your dehumidifier is not running you may need to replace the overload. You can use a multimeter to check the continuity. Please remember to disconnect the power before starting your repair. This is a genuine OEM part.
-
Sold individually.
-
This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.