1-877-754-0308
Hello!
You're visiting the Easy Appliance Parts site in Canada.
Would you like to shop on the U.S. site?
This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.
This single ¼” compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.
Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".
This clamp is sold individually.
The transport wheel attaches to the base of the dishwasher and allows you to roll the dishwasher into the cabinet during installation.
Sold individually.
This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. This kit includes the compressor, grommets, drier tube, overload, start relay, run capacitor, wire and terminal cover.
The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.
The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.