1-877-754-0308
Hello!
You're visiting the Easy Appliance Parts site in Canada.
Would you like to shop on the U.S. site?
Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.
Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.
Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.
This front bearing and seal kit comes with the adhesive.
Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.
Creates a seal between the rear panel and the rear of the drum.
This clamp is used to secure the drive motor.
This screw is sold individually.
This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.
Fits around the front of the drum.
This is the lock clip, which is used to lock in the front panel. Sold individually.
11-16 x 3/4 Sold individually.
Can be used to re-coat dryer drums.