11085088401 Kenmore Dryer Parts List

Search the entire 11085088401 by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

Blower wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Easy Part #:: EAP11743811

Availability:: In Stock

Price:: $81.60

Stacking kit

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Easy Part #:: EAP888067

Availability:: In Stock

Price:: $59.57

Heating element connection wire kit (wire replacement kit)

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

Easy Part #:: EAP334206

Availability:: In Stock

Price:: $12.70

Drum support shaft - rear shaft with right hand threads (shaft)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Easy Part #:: EAP11753708

Availability:: In Stock

Price:: $60.59

Cover screw (screw)

Sold individually.

Easy Part #:: EAP11740701

Availability:: In Stock

Price:: $9.15

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Easy Part #:: EAP11727942

Availability:: In Stock

Price:: $75.69

Thrust washer

This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.

Easy Part #:: EAP11740482

Availability:: In Stock

Price:: $9.15

Drive motor with threaded shaft - 120v 60hz (drive motor assembly)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Easy Part #:: EAP334287

Availability:: In Stock

Price:: $235.86

High limit thermostat - l295-50f (thermostat)

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.