1-877-754-0308
Hello!
You're visiting the Easy Appliance Parts site in Canada.
Would you like to shop on the U.S. site?
This hose can handle hot or cold water and is five feet long.
Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 145 degrees Fahrenheit and a differential of 20 degrees. Meaning that with this thermostat, the heating element will cut out at 145 degrees and cycle back on once the internal temperature drops by 20 degrees.
This is the bearing for the lid hinge. Sold individually.
A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.
This part is used to activate the lid switch when the lid opens/closes.
Used to drain water.
Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.
Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench.
Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.
The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.
Sold Individually.
This front bearing and seal kit comes with the adhesive.
200F
This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.
Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.