1-877-754-0308
Hello!
You're visiting the Easy Appliance Parts site in Canada.
Would you like to shop on the U.S. site?
The latch kit includes the latch and the snap. This part is used to keep the soap dispenser cover closed until activated. It is located on the inside of the door panel on the right side. If your dishwasher is not dispensing detergent, or the latch is broken or damaged, you may need to replace the latch kit. This is a genuine OEM part.
This hose is used to drain the water into your sink.
Sold Individually.
The light gray upper roller and clip attach to the upper rack to allow the dishrack to move in and out along the track of the dishwasher. If your dish rack is not moving in and out of the dishwasher properly you may have a broken or missing wheel and it will need to be replaced. The roller and axel is made of plastic and measures 1 1/2” W x 2 1/2” high x 1” deep. This is a genuine OEM part and is sold separately.
This kit also includes the lid hinge pin, spring, snap and latch.
Have to be installed with adhesive which is sold separately.
This float assembly comes with the nut.
This complete pump seal kit comes with four black rubber rings, a white fiber gasket, and a screw.
Water that fills your dishwasher lifts this float, and when it reaches a certain level, it acts as a trigger for the float switch. The float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher.
This water inlet valve is intended for use with horizontal motor dishwashers. It uses a 3/8 of an inch valve tubing and a mounting bracket.